Install the Endpoint Module

Now that you've created policies that address situations that occur when the Device Control endpoint module is initially installed, you can begin installing the Device Control endpoint module.

To Install the Endpoint Module:

These instructions assume that the Endpoint Security Agent is already installed on your endpoints. If the Agent isn't already installed, refer to the Agent Install Guide.

  1. From the Endpoint Security Console, select Manage > Endpoints.


  2. Select the endpoints that you want to install the Device Control endpoint module on. Then click Manage Modules.

  3. Select the Device Control check box for each endpoint that you want to install the module on. Then click OK.

    4. Before you install the module on all endpoints, we recommend installing the module on a few endpoints that represent your organization. This test install will reveal any potential software conflicts that to resolve before rolling the module out to your entire organization.


    • Device Control module installation begins.
    • Module installation progress displays on the Manage > Endpoints page.
    • Remember, Device Control module installation does not complete until the endpoint is rebooted.