Installing the Ivanti Wake on LAN Module Server Component

To begin using Ivanti Wake on LAN (WOL), you must first install the module server component on your Ivanti Endpoint Security (Ivanti Endpoint Security) server.

Install the Ivanti Wake on LAN platform component using the Ivanti Installation Manager. For additional information see Using Installation Manager in the Endpoint Security Help.

The Ivanti Wake on LAN module is considered part of the Ivanti Endpoint Security platform and is therefore listed as a platform component within Installation Manager.

  1. Select Tools > Launch Installation Manager.
    Installation Manager opens to the New/Update Components tab.

  2. Select a Suite Version radio button.

    • If you are updating the entire suite, select the radio button for the latest Suite Version.

    • If you are only installing new modules, leave the current suite version selected.

    When you select a Suite Version, other suite versions their components are grayed out to prevent mixing.

  3. Select the Ivanti Wake on LAN check box for your version of Ivanti Endpoint Security.

  4. Click Install.
    The Database backup recommended dialog opens.

    During the module install, the installer will update your existing database(s). In the event of hardware failure or data corruption a database backup can ensure you still have functional data in order to restore database files. Refer to Creating a Database Backup in the Endpoint Security Help for additional information.

  5. Select Next.
    The Ready to Install dialog opens.

  6. Click Install.
    The following table describes the steps for each dialog page.

    Dialog

    Step(s)

    If the Prerequisites page opens:

    Your server does not meet the recommended system requirements to install the selected content.

    • If you receive failure(s), you must cancel the installation and resolve the failures before you can install the content.

    • If you receive warning(s), you may proceed by clicking Next. Ivanti recommends resolving the warning(s) before proceeding.

    If the Install/Update Components page opens:

    Click OK to begin the component(s) installation.

    If the Install Status page opens:

    The installation of component(s) begins.

    The selected component(s) begin downloading and installing.

  7. After installation completes, review the Confirmation page. Click Finish when you are done.

  8. Click Finish.
    The Confirmation page closes.

The Ivanti Wake on LAN platform component is installed. To begin using the platform component, reopen Ivanti Endpoint Security.

After Completing This Task:

Complete Post Installation Tasks.