Updating the Ivanti Remote Systems Management Module

Periodically, Ivanti releases updates for Ivanti Remote Systems Management. Install the latest release to keep Ivanti Remote Systems Management up to date. Ivanti recommends installing updates immediately.
Update Ivanti Wake on LAN using the Ivanti Installation Manager.

  1. Select Tools > Launch Installation Manager.
    Ivanti Installation Manager opens to the New/Update Components tab.
  2. Select a Suite Version radio button.
    • If you are updating the entire suite, select the radio button for the latest Suite Version.
    • If you are only installing new modules, leave the current suite version selected.

    3. When you select a Suite Version, components for other suite-versions are grayed out to prevent mixing.

  3. Select the Ivanti Remote Systems Management check box for your version of Ivanti Endpoint Security.

    4. This check box is only available if there is an update for the module.

  4. Click Install.
    The Database backup recommended dialog opens.

    5. During the module install, the installer will update your existing database(s). In the event of hardware failure or data corruption a database backup can ensure you still have functional data in order to restore database files. Refer to Creating a Database Backup in the Endpoint Security Help for additional information.

  5. Select Next.
    The Ready to Install dialog opens.
  6. Click Install.
    The following table describes the steps for each dialog page.

    7. Dialog

    Step(s)

    If the Prerequisites page opens:

    Your server does not meet the recommended system requirements to install the selected content.

    • If you receive failure(s), you must cancel the installation and resolve the failures before you can install the content.
    • If you receive warning(s), you may proceed by clicking Next. Ivanti recommends resolving the warning(s) before proceeding.

    Click Print for a hard copy of prerequisite deficiencies. Click Retry to reassess the server.

    If the Install/Update Components page opens:

    Click OK to begin the component(s) installation.

    When the Don't show this again check box is selected it collapses the Install/Update Components dialog and this dialog will no longer be shown.

    If the Install Status page opens:

    The installation of component(s) begins.

    The selected component(s) begin downloading and installing.

  7. After installation completes, review the Confirmation page. Click Finish when you are done.
  8. Click Finish.
    The Confirmation page closes.

The module is upgraded.