MobileIron Core appliance setup

If you are installing a physical appliance, you will need to configure the system either with a standard VGA monitor and keyboard, or via the serial console. To access to the serial console, you can use a PC or remote console system. Use Putty or HyperTerminal if you are using a PC.

To set up console access:

  1. Connect a console cable to the appropriate port on the back of the appliance.
  2. Connect a serial cable to a PC or remote console system.

Hardware appliances

The following table describes which MobileIron appliances are supported on Core and Enterprise Connector .

table 1. Appliances supported by Core and Enterprise Connector

Product

Supported

Compatible

Core and Enterprise Connector

M2200

N/A

Core

M2250, M2600

N/A

Maximum number of supported devices

The following table summarizes the maximum number of supported devices on each MobileIron appliance.

table 2. Device capacity for Core appliances

Model

Maximum Number of Devices

Testing Standard

M2600

200,000

The maximum number of supported devices, for each appliance, is based on a rate of 1 device registration per second. This maximum number of supported devices will change, depending on individual use cases and work load for each appliance.

NOTE: IPv4 is supported.

M2200/M2250

 

60,000