Installing the Connector ISO Package
After the VM environment is set up, you can install the Connector ISO package.
|
1.
|
Log in to the VM Client. |
|
2.
|
In the directory tree on the left, right-click the device on which you want to install the package. |
|
3.
|
Select Edit Settings from the drop-down menu. |
|
4.
|
Select CD/DVD Drive 1. |
|
5.
|
Make sure that Datastore ISO File is selected. |
|
6.
|
Click Browse and navigate to the directory where the ISO package is kept. |
|
7.
|
Select the ISO package. |
|
8.
|
Click Open to return to the VM Properties screen. |
|
9.
|
Click OK to return to the previous screen. |
|
10.
|
Right-click the device on which the package is to be installed. |
|
11.
|
Select Power, then Reset. |
|
12.
|
Click Yes to reset the virtual machine. |
|
13.
|
Observe the status messages at the bottom of the screen. |
|
14.
|
Click the Console tab. |
The following screen appears after the ISO package is installed:
Welcome to the Connector Installation Program
To install the Connector, type:
install<ENTER>
To boot from your local hard disk, type: <ENTER>
Note: System will boot from the local hard disk if no key is pressed.
|
17.
|
The CentOS installation begins and might take several minutes. |
|
18.
|
When prompted, press Enter to log in. |
The Configuration Wizard starts.