Using the Configuration Wizard

The Configuration Wizard starts after the ISO package is installed. Use the Configuration Wizard to set the following:

•system properties/admin account

•network settings

•final configuration settings

During the configuration, you will be prompted to set the following credentials:

•privileged access: provides access to the more important Connector CLI commands

•SSH administrator: provides access to the Connector CLI basic commands

You will also need to provide the Tenant Admin credentials you received when you signed up for the device management service.

System Properties and SSH Admin Account Setup

 

Prompt

What to Do

1

Welcome to the MobileIron Configuration Wizard

Use the “-“ character to move back to a previous field.

Proceed with system configuration (yes/no):

Enter yes.

2

End User Licensing Agreement

Enter yes to accept.

3

Enter a privileged access password:

Set a password for privileged access (6-20 alphanumeric characters).

4

Confirm password

Re-enter the password you just set.

 

Network Setup

 

Prompt

What to Do

1

Fully qualified domain name for this system (ex: myhost.myserver.com):

Enter the fully-qualified domain name for this system.

2

Default domain:

Enter the default domain for this system.

3

IP address:

Enter the IP address for this system.

4

Netmask:

Enter the subnet mask associated with the IP address you just entered.

5

Default gateway address:

Enter the default gateway address for this system

6

DNS name server 1 address:

Enter the IP address for a DNS name server.

7

DNS name server 2 address:

Enter the IP address of another name server, or press Enter "none" and go to step 9 if you have finished entering name servers.

8

DNS name server 3 address:

Enter the IP address of another name server, or press Enter if you have finished entering name servers.

9

Enable remote shell access via SSH (yes/no):

Enter yes to enable SSH access.

10

Enable the NTP service (yes/no):

Enter yes to enable the optional NTP service and begin specifying time sources.

11

NTP server 1 hostname or address:

Enter the hostname or IP address of a time source.

12

NTP server 2 hostname or address:

Enter the hostname or IP address of another time source, or press Enter and go to step 15 if you are finished entering time sources.

13

NTP server 3 hostname or address:

Enter the hostname or IP address of another NTP server, or press Enter "if you are finished entering NTP servers

14

Specify an HTTP proxy (yes/no):

Enter yes to set up an HTTP proxy or enter no to skip this step.

15

Enter a time in 24 hour format in UTC timezone to check for software updates daily

Enter the time at which you would like the service to check for Connector software updates.

Example, to specify 2 pm as the time to check for updates, enter 14:00.

If updates are found, they will be applied automatically.

Final Configuration Settings

The settings you just entered are displayed.

 

Prompt

What to Do

1

Apply this configuration?

Enter yes.

The settings you entered are applied. After several minutes, a SUCCESS message indicates that Connector installation is complete. Next, the Connector registration process begins.

2

This Connector will now be registered. Your Tenant credentials are required to perform the registration.

Onboard LDAP or PKI connector app using UEM device authorization flow. (yes/no):

To proceed with the Ivanti Connector registration, enter 'no'.

3

Enter your Tenant Admin Username:

Enter the Tenant Admin username you received when you signed up for the device management service.

4

Password:

Enter the Tenant Admin password.

5

Registration Successful!