Command Reference Guide

Supporting Pulse One Appliance 2.0.2102

Introduction

Using the Command-Line Interface

This section assumes you have already performed the initial setup of Pulse One. For detailed information, see the Pulse One Appliance Getting Started Guide.

To connect the CLI:

1.You can connect to the CLI using one of the following options:

•An ASCII terminal or emulator that can connect to the serial console. It must have the following settings: 9600 baud, 8 bits, no parity, 1 stop bit, and no flow control.

•A computer with an SSH client that is connected to the appliance Primary port (in rare cases, you might connect through the Auxiliary port).

2.At the system prompt enter the following command if the appliance resolves to your local DNS:

ssh [email protected]

Otherwise, at the system prompt enter the following command:

ssh admin@ipaddress

3.When prompted, enter the administrator password. This is the password you set during the initial configuration process.