Actions

Use Actions By Event or Actions By Type to configure global actions. Global actions are executed at the start of the user session (logon), when the user session is refreshed or reconnected, when network connectivity changes, and when the user session is logged off.

The user's Event Log will be appended with the results of the applied settings. You can view the contents of this Event Log in the Workspace Analysis window of this user.

It is possible to Move and Duplicate settings related to Actions. This makes it possible to:

• duplicate application settings and move them from one application to another
• duplicate application settings and move them to a global level
• duplicate global settings and move them to an application
• move global actions to an application
• move application actions to global

When moving actions from an application to global, the timing changes as displayed in the table below:

Timing of application action	Timing of global action
At application start	At logon before other actions
At application end	At logoff

When moving actions from global to an application, the timing changes as displayed in the table below:

Timing of global action	Timing of application action
At logon before other actions	At application start
At logon after other actions	At application start
At refresh	At application start
At reconnect session	At application start
At logoff	At application end

Please note that executing an action on session reconnect requires that Workspace Control refreshes the session when it reconnects. Therefore, when configuring actions to be executed at session reconnect, make sure the option Do not refresh Workspace when reconnecting to a session is not enabled (at Composition > Lockdown and Behavior, in the Workspace Composer section).