Security Controls

Overview of Linux Patch Management

Only those Linux machines that meet the minimum requirements are eligible to be scanned and patched by an agent. See the System Requirements for complete information.

Linux machines are scanned and patched using agents. The process is as follows:

1.Identify your Linux machines.

If you know the identities or whereabouts of all your Linux machines, you can create a Linux machine group.

If you are unsure about the identities and locations of all your Linux machines, perform a power status scan on the My Domain or Entire Network group. The scan will identify the OS type of each machine in the group and your Linux machines will be displayed on the Linux patch tab in Machine View.

2.Create one or more Linux patch groups and configurations.

Create a Linux patch group: This is optional but it is generally a good idea. Creating a patch group gives you greater control over your scans and deployments. With a patch group you can scan for and deploy a particular set of patches.

Create a Linux patch scan configuration: You use this configuration to specify exactly how your Linux machines will be scanned.

Create a Linux patch deployment configuration: You use this configuration to specify exactly how patches will be deployed to your Linux machines.

3.Create one or more agent policies.

An agent policy defines exactly what an agent can or cannot do. You will create one or more Linux patch tasks in the agent policy. In each task, you specify when the task will run on an agent machine and which configurations should be used during the scan and deployment processes.

It is perfectly fine to mix Windows tasks and Linux tasks in the same agent policy. Windows tasks will be ignored by your Linux machines, and vice versa.

4.Install the agent policy.

Each Linux target machine must be properly configured before you can perform a push install of an agent. See System Requirements for more details.

One option is to perform a "push install" of the agent from the Security Controls console. You can do this a couple of different ways:

Within your Linux machine group, select the machines in the bottom pane and then click Install / Reinstall agent.

On the Linux patch tab in Machine View, right-click the Linux machines and install the desire agent policy.

If you performed a power status scan on your Linux machines, you can also perform this step from the Results list in the navigation pane.

Another option is to manually install an agent on each of your Linux machines. For details, see Manually Installing Agents.

5.Use the agent.

The agent will automatically perform its tasks and report the results to the console. If you want to manually control the agent, you do so using a command line utility. For details, see Using an Agent on a Target Machine.

Agents installed on Linux machines are not listening agents. This means you cannot send commands to the agents from the console. Changes you make to the policy are applied when the agent checks in with the console.

 


Was this article useful?